20
OPERATING
INSTRUCTIONS
A blade on the underside of the guard
hood automatically cuts the cutting
line to the optimum length. This is
covered by a guard. Remove the guard
before you start working and replace it
when you have finished working.
Starting the engine when cold
Fill the tank with the required amount of oil/petrol mix. See Fuel and oil.
(1)
Set the machine down on a hard, level surface.
(2)
Set the choke lever to the ‘COLD’ position.
(3)
Press the fuel pump (primer) 10 times (
this is found under the air filter housing
).
(4)
Ensure the 'STOP SWITCH' (4) is set to the 'ON' position.
(5) To secure throttle lever:
a. Press throttle release (1)
b. Press throttle lever (2)
c. Press throttle lock (3)
d. Let go of the throttle release (1)
& throttle lever (2).
Note: By repressing the throttle lever this will
release the throttle lever from the locked position.
(6)
Hold the machine firmly and pull out the starter cord until you feel it start to resist.
Then tug sharply on the starter cord 4 times. The machine should start.
Never allow the starter cord to snap back. This may damage the machine.
(7)
Once the engine has started, move the choke lever immediately to the ‘HOT’ position
and allow the machine to warm up for approx. 10 seconds.
•
If the engine does not start up, repeat steps 6-7 above.
Operation
PRIMER
Line cutting
blade
Blade
protector
1.
2.
4.
3.
Choke
Not
for
Reproduction
Содержание RTS1226
Страница 34: ...34 NOTES N o t f o r R e p r o d u c t i o n ...
Страница 35: ...35 NOTES N o t f o r R e p r o d u c t i o n ...
