NOTE:
* If registered points are more than 63 points, print “Memory Full” and stop action.
Marker
: Use this if user sees other points.
Finder
: Use this to move finder screen.
UnDo
: Cancel the registered point.
Done
: Return to previous menu.
Unregist
: Deleting registered pixel.
NOTE:
* No more existing registered pixel; print “Memory empty” and stop action.
Marker
: Select to continue unregistered action.
UnDo
: Cancel the unregistered point.
Done
: Return to previous menu.
Default
: Recover to factory adjustment state.
- Focus Aid
To prevent the spread of light, AE mode changed to Shutter Fix Mode.
Min SHT (sec)
: Adjust minimum shutter speed.
Zoom
: Zoom to focus window.
Adj
:
Adjust.
Start
: Start measurement of maximum focus value.
Stop
: Stop the measurement and initialize maximum focus value.
NOTE:
* FAD Max: Hold maximum focus value.
* FAD Val: Print present focus value.
* Usage:
Step 1: Point target to focus window.
Good target: higher contrast, more complex patterns.
Step 2: Minimize the spread of light by adjusting shutter speed.
Step 3: Turn the lens focus ring to end, start “Adj”.
Step 4: Turn the lens focus ring slowly to opposite side; record max focus value.
Step 5: If current fad value is lower than max fad value, stop turning focus ring.
Step 6: Adjust focus ring to be closer to the max fad value.
3) Lens
: Select lens (DC lens/Video lens/Manual lens)
- Iris Speed: Adjust Iris speed (only for DC/Video Lens).
NOTE:
* If iris speed is too high, AE hunting can occur.
* If iris speed is too low, IRIS adjustment can operate too slowly.
4) LLC (Line Lock Control)
Active only when AC power is used. Select Int (Internal)/Ext (External) mode.
If mode is set to Ext, Sync Phase can be adjusted.
5) Day/Night
-
Detection
: Configure D/N change method (Internal/Fix-Day/Fix-Night/EXT-IN).
Internal
: Operating DN changes with internal detection algorithm.
Fix-Day
: Day mode fixed.
Fix-Night
: Night mode fixed.
External
: Work with EXT-IN mode. If port input voltage is high,
DN mode is Night; if port voltage is low, DN mode is Day.
-
Burst
: Select burst signal on/off in night mode.
- 12 -
-
Delay (sec)
: Select delay time for D/N mode to change.
