Direction
area, detecting direction of moving out.
*) Don’t use as a signal for starting video
recording.
*) Not supported in Simple mode.
Move
Clockwise
Line
Event will occur the object moves in a
clockwise direction that start around.
*) Don’t use as a signal for starting video
recording.
Move Conter-
Clockwise
Line
Event will occur the object moves in a counter-
clockwise direction that start around.
*) Don’t use as a signal for starting video
recording.
Path Event
: Detect route between two zones (max. detection of 10 paths.)
NOTE:
* Disabled zone cannot be configured.
* Not supported in Simple mode.
*
The path event detection can be inaccurate.
Output Direction Setup
: Same as zone output configuration.
Clear All
: All path combinations clear.
2) Env. Setup (Environment setup)
: Configurations for each PVA function.
-
Md Sens (MD Sensitivity)
: Adjust motion sensitivity (HW sensitivity).
-
Loiter Time (min)
: Time to judge if loitering object.
-
Abandon/Absent Setup
Sens (Sensitivity)
: Adjust sensitivity of abandon/absent detection.
Det Time (min)
: Time to judge if absent/abandon area.
Rst Time (sec)
: Time to maintain event. After this time, background will update.
-
Scn Chg Setup (Scene Change Setup)
Sens (Sensitivity)
: Adjust sensitivity of scene change detection.
Chg Ratio
: Adjust judgment ratio of change from the stored background.
Det Time (sec)
: Time to judge scene changes.
Rst Time (sec)
: Time to maintain event. After this, background will update.
Unfocus
: Detection on/off of unfocused state/defocused state.
- Windy Setup (Windy Area Detection Setup)
:
Not applied in Simple PVA mode.
Sens (Sensitivity)
: Adjust sensitivity of windy object detection.
Det Time (sec)
: Time to judge if windy object.
Rst Time (sec)
: Time to release if windy object stays with no motion
3) Display Setup
: Configuration for information on screen.
NOTE:
* Priority: Abandon/Absent > Loiter > Moving Object > Windy
* Same priority: large object size order
Alarm
: Represent alarm icon on right-up side by of screen.
Counter
: Represent counting on left-bottom (Det Only: When an event occurs).
Zone Area
: Represent active zone.
Moving Object
: Represent moving object with white rectangle.
Loitering
: Represent loitering object with green rectangle.
Abandon/Absent
: Represent abandon/absent area with wine colored rectangle.
Windy Area
: Represent moving object with violet rectangle.
4) dTracking Setup
: Configurations for digital Pan/Tilt/Zoom.
- 9 -
NOTE:
