- D/N Threshold
: Configure the threshold level for D/N mode to change
(Low/Mid/High/User).
NOTE:
* User Mode: Difference between D>N Level and N>D Level must be more than 2
and D>N must be less than N>D.
D>N: Adjust level of changing point of Day -> Night.
N>D: Adjust level of changing point of Night -> Day.
-
OPD
: Optical detector value. Represent present physical brightness.
-
Use Alt Camset (N), Alt Camset
: Select camera configuration set to apply in night
mode.
NOTE:
* Not supported in single Camset mode.
6) EXT-I/O
-
D/N OUT (Day&Night Output)
: Select output method, No Func/D/N Out/AUX0.
AUX0
: User defined output 0.
Set AUX0
: Output voltage through to D/N OUT port [Open Collector (5V/10mA)].
-
ALARM OUT
: Select output method, No Func/Alarm Out/AUX1.
AUX1
: User defined output 1.
Set AUX1
: Output voltage through to D/N OUT port [Open Collector (5V/10mA)].
- D/N IN
: Select input method, No Func/Alt Camset.
Alt. Camset
: When inputting signal, change camera configuration.
Select Camset number.
7)
Counter
: Configurations for output of counting machine.
-
,
:
Represent counting value/adjust offset value.
-
Alarm On Zero
: When counter value reaches zero, camera will be alarmed.
Preset Cnt1, Cnt2
: When counter reaches zero, counter value will be reset to this
value.
Reset
: Initialize counter (Default Zero or Alarm on zero enabled: Offset Value).
TextOut to Comm
: Event string sends through RS-485 lines.
NOTE:
* Event Out must be activated.
- 13 -
