2
CONNECTORS AND CONTROLS
Rear Panel
1. ETHERNET (Network Port)
RJ-45 port provides connection (RJ-45 connector) to Internet, Ethernet (10Base-T/100Base-T). The
green LED indicates that there is connection to the Network. This connection also provides PoE (Power
over Ethernet). When using PoE, a PoE device, such as the NETSWITCHPOE-24, is required.
2. POWER
A 2-pin screw terminal for 12 VDC connection. A red LED indicates that there is power to the camera.
3. AUDIO
Not supported by ViconNet (for future use).
4. VIDEO OUT
1.0 V p-p/75 ohm composite video signal is provided at this BNC connector.
5. RESET
Use the reset button to reset the camera back to factory defaults; follow the steps below:
Step 1:
Switch off the camera by disconnecting the power cable.
Step 2:
Press and continue to hold the reset button. Reconnect the power cable while continuing to hold
the reset button.
Step 3:
Keep holding the reset button depressed about 6 seconds and then release it. The unit will start
up with factory default settings.
6. MENU BUTTONS
– (Menus vary according to model)
Use the Menu button to access the OSD menus for camera setup. Menu selections are model
dependant. Refer to the OSD Menu section that follows.
XX181-20-00 Rev 908 VN-957V5 IP Camera
