3
XX207-00-02 Rev 910 MP-980DN Camera
INSTALLATION
Installing the Lens
To install the lens, screw it into the camera’s lens mount turning counterclockwise until it stops. A C/CS
adapter is supplied for those applications where a lens with a C-mount is required. Connect the lens cable
plug to the connector on the side of the camera. It is important to use a megapixel lens with a megapixel
camera to maintain the detail provided by the megapixel camera.
In the Video Settings menu, select Fixed
“Iris mode”
initially to adjust lens; this fixes the shutter to adjust
focus. After the lens is focused correctly, then select Indoor or Outdoor for the environment.
If backfocusing is necessary, use small hex tool provided to loosen the hex screw on the side of the camera.
This releases the ring around the lens to adjust the backfocus. With the lens installed and the camera con-
nected to a monitor (refer to Connections section that follows), open the iris completely. Turn the ring as
needed until the image is sharpest. Tighten the hex screw to lock the backfocus adjustment ring. Refer to the
manual for any other lens for making lens adjustments. Other lens adjustments are done from the Video con-
figuration screen.
Connections
Follow the procedures below to connect the IP device to other equipment in the system.
1. If using 12 VDC, connect the power adaptor to the camera and then to an appropriate power
source. If using 24 VAC, connect wires to terminals 5 and 6 on the screw terminal block.
