Vicon AurorAcord, Инструкция по эксплуатации

Страница: 78 / 90

XX091-01-01 Rev 902 AurorAcorD Reference
•
65
Browse
Select the Browse button to select video file. You may also use File > Open. There will be no indication that
the file has been selected. You must select Play to run the file.
Play
Use the Play button to run video that you have selected with File > Open or the Browse button. The Play
button is also used to resume play after the Stop button is pressed.
Stop
Use the Stop button to halt video playing onscreen. When you press Play, the video will resume from the
stopped point in time. Also press the Stop button before changing the Time Index or Playback Speed
functions.
Select Camera
If video from more than one camera is stored on the CD, use this feature to select the camera whose video
you wish to play.
Playback Speed Slide Bar
Press the Stop button and then use the slide bar to play back video at the recorded speed (1x) or to varying
speeds from ¼ to 4 times the recorded speed.
Time Index
Press the Stop button and then use the slide bar to move to different points in the timeline of recorded video.
You can use the Start Time and End Time messages as reference points.
Floppy Player
Video images may viewed on a PC using the AurorAcorD Floppy Player or Windows Media Player. These
images must have been saved to a floppy disk using the Archive Floppy function. This function is discussed
in the Archiving section of this manual. The filename for the archive will be CameraXX.avi, where XX is the
camera number 1-16.
To use Windows Media Player instead of the AurorAcorD Floppy Player, install the codec driver as discussed
in the following section and in
Viewing Video Images from Floppy Disk . You may use the Windows Media
Player help file for program-specific information.
The number of images saved on the floppy depends upon the Quality setting (discussed in the Recording
section of the Programming chapter). For a Quality setting of Normal, over 90 images may be saved to disk.
Note that audio is not recorded to floppy, but is available with data archived to CD (if enabled).
The File and Options Menus are shown below.
Select Open to select a video file with extension AVI.
Exit the AurorAcorD Floppy Player using this command.
Place a check mark beside Continuous Play to play the file repeatedly
until the Stop AVI File button is pressed. Remove the check mark to
play the file once.