Viavi mA-3011, Руководство по эксплуатации

Страница: 55 / 64

Chapter 6 Care and Maintenance
Module Removal/Installation Procedures
mA-3011 AXIe Embedded Host Module Operation Guide Rev. C0
Page 6-6 May 2020
8 When the upgrade process is complete, the user will be prompted to power cycle the
system.
9
Power cycle the Chassis to apply the new changes.
Module Removal/Installation Procedures
This section covers removing and installing the module. The procedures in this section are
intended for Qualified Service Personnel.
Removing the Module
How to Remove Module
1 Power down the Chassis.
2 Fully loosen the captive screws on each side of the module.
3 Grasp the module Securing Latches and pull the Latches outwards and away from
the module to disconnect the module from the Backplane Connectors.
4
Pull until the Securing Latches are at a 90° angle with the front of the module. See
Figure 6-4 on page 6-8 .
5 Grasp the module and pull to remove the module from the Chassis.
If the module is being returned to the factory for service, refer to section “Shipping the
mA-3011” on page 6-9 for important information.
CAUTION
Modules are ESD sensitive and should only be installed, removed and/or serviced by
Qualified Service Personnel.
Mise en Garde
Les modules sont sensibles aux DES et ils doivent seulement être installés, enlevés ou
entretenus par du personnel de service qualifié.