Viavi mA-3011, Руководство по эксплуатации

Страница: 42 / 64

Chapter 4 Operation and Control
mA-3011 Network Configuration
Rev. C0 mA-3011 AXIe Embedded Host Module Operation Guide
April 2020 Page 4-7
Set Module to Use DHCP IP Address
1
Power on the CMP System.
2
Open a web browser window.
3
Enter the mA-3011 IP address in the browser window URL field.
4
Navigate to the mA-3011 Networking page (see “CPUC Networking Page” on
page 5-5 ).
5 Select the module instrument slot and set the module Network Mode to DHCP .
– Module Network Mode menu: Slots section of the Network Settings Table
6
Select DHCP Mode.
7
Select the Apply button. At user prompt, select the Apply and Reply button.
NOTE
When DHCP Configuration is initiated, the mA-3011 IP Address updates and the Web
Browser UI connection will be lost. Refer to section “Locate mA-3011 IP Address” on
page 4-5 .
NOTE
The system will initiate an auto reboot sequence that takes approximately 10 to
15 seconds. If the system does not auto reboot within one minute, press the Power
On/Standby button and refer to the following:
•
If the Power On/Standby button turns green, the system has initiated the reboot
sequence. Wait while the system completes the power up process.
•
If the Power On/Standby button turns yellow, the system failed to initiate the power
on sequence. Press the Power On/Standby button again to initiate the power on
sequence and wait while the systems completes the power up process.