vesper marine WatchMate 850, Инструкция по установке

Страница: 13 / 16

WARNINGS
This AIS Transponder works in conjunction with other vessels and systems, such as other AIS transponders and
GPS devices. The accuracy of this device and the AIS system can be affected by many factors, including
equipment failure or defects, environmental conditions and incorrect installation, handling or use. Vesper
Marine does not warrant that this product is error-free. It is the user’s responsibility to exercise common
prudence and navigational judgment. This device should not be relied upon as a substitute for such prudence
and judgment. Always maintain a permanent watch so that you can respond to situations as they develop.
The prudent mariner will not rely on a single aid to navigation. The user should verify the information obtained
from this AIS Transponder is in accordance with expected situations and conditions. The information is not
guaranteed to be accurate or reliable and this AIS Transponder is not a substitute for proper seamanship.
Vesper Marine Limited cannot be held liable for any injury, damage or loss, caused by, during, or because of
the installation, use or inability to use this device. This AIS Transponder is to be installed and used entirely at
your own risk. By installing and/or using this AIS Transponder you fully accept all risk and agree to hold Vesper
Marine Limited harmless. If you do not agree to accept all risk, return this product unused in its original factory
condition to your dealer for a full refund.
Intended Use
This product is intended to be used on leisure or commercial vessels (excluding IMO/SOLAS class).
Vesper Marine has designed and manufactured this product to be used only aboard vessels.
Warranty Void
Do not disassemble the unit or remove the screws which hold it together. The unit is sealed and disassembly
will void the warranty.
FCC Warning:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Industry Canada Warning:
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
This device complies with RSS-310 of Industry Canada. Operation is subject to the condition that this device
does not cause harmful interference.
To satisfy RF exposure requirements for mobile transmitting devices, a separation distance of 1 metre or more
should be maintained between the antenna of this device and persons during device operation. To ensure
compliance, operations at closer than this distance is not recommended.
The antenna used for this transmitter must not be co-located in conjunction with any other antenna
or transmitter.
This device has been designed to operate with an antenna having a maximum gain of 3dBi. Antennas having
a gain greater than 3dBi are strictly prohibited for use with this device. The required antenna impedance is
50 ohms.
To reduce potential radio interference to other users, the antenna type and its gain should be chosen that the
equivalent isotropically radiated power (EIRP) is not more than that required for successful communication.