VES VIP-009, Инструкция по эксплуатации

Страница: 5 / 18

EN
G
LI
SH
EN
G
LI
SH
CLEANING
Unplug the appliance from mains. Detach water tank. Pour water
remnants out of water tank. Rinse water tank with clean water, let
dry. Wipe the base with wet cloth. Install water tank back
onto the
base. Roll power cord carefully. For appliance cleaning use only
the clean water or neutral cleancers. Do not use the caustic or
abrasive cleancers (e.g. vinegar or decalcifiying agents) as they
may damanage the appliance. Do not wash the tips with water
hotter than 40
°C .
- If you used the mouth wash its remnants must be cleaned
away. For this clean the tank with clean water, pour the filtered
clean water in the tank and drain through the used tip by
switching the appliance on.
- Appliance desinfection. Pour 200-300 ml of 40 % medical
alcohol solution into the tank and drain it through the tips by
switching the appliance on. One hour later, rinse the tank with
clean water, pour the filtered clean water in the tank and drain
it through the tips.
Storage
Keep the unit assembled in a clean, dry place, away from
children.
When transporting and storing the device, observe the following
rules:
- The unit must be empty and completely dry.
- After transportation of device at low temperatures must be left
in the room for at least 2 hours before using.
Problems and solutions
Problem
Possible
reason
Solution
Leakage between
the tip and the
tip rotating
mechanism. Tip incorrect
installation. Eject the tip and
install correctly.
Leackage of
periodontal tooth
pocket tip end. Tip if torn. Change the tip.
Leackage of hose. Hose is torn. Change the hose
at service center.
Leackage of water
tank. Incorrect
installation of
the water tank
or there is no
rubber plug.
Rubber
plug placed
incorrectly.
Install the water
tank correctly.
Isntall the rubber
plug back. If plug
lost, address to
service center.
Install the rubber
plug correctly.
Low water pressure
or there is no water
coming. Water tank
is incorrectly
placed on the
base. There
is no water in
tank. Place water tank
well.
Fill tank with water.
The appliance is
switched on. Motor is not
working. Make sure there is
current in net.
Tips and tank are
correctly installed.
There is water in
tank but the water
is not running. There may be
the airlock in
the device. To eliminate the
airplug turn the
unit on and gently
retract the air
from a tip without
swallowing suddenly
entered the water.
PRECAUTIONS
Use only the filtered water! Tap water contains salt,
sand, lime, etc., which will clog the appliance. The
8 9