Vertiv NetSure PSS12/2000-19B, Инструкция по установке и эксплуатации

Страница: 39 / 44

Vertiv
| NetXtend +12 VDC Bulk Output Power System Installation and User Manual (UM588706000) | Rev. H
37
INITIALLY STARTING, CONFIGURING, AND CHECKING
SYSTEM OPERATION
Important Safety Instructions
CAUTION! Performing various steps in the following procedures may cause a service interruption and/or
result in the extension of alarms. Notify any appropriate personnel before starting these procedures. Also,
notify personnel when these procedures are completed.
Initial Startup Preparation
Ensure that all blocks, except the last one have been checked.
If the system was integrated into an Open Compute IT Rack and shipped to its final destination with rectifiers pre-
installed, REMOVE THE SHIPPING SUPPORT BRACKET BEFORE POWERING THE SYSTEM. See
Figure 23
.
Figure 23
: Removing Shipping Support Bracket - List 9, 19, 23, 24
Initially Starting the System
Procedure
1. Apply AC input power to the system by closing ALL external AC disconnects or protective devices that
supply AC power to the module mounting assembly(s).
1. Insert rectifier modules and SCC controller into the module mounting assembly(s).
2. Insert BBU modules into the module mounting assembly(s).
3. Recommended to insert blank covers into empty slots.
4. The system is pre-configured. Refer to the master upstream supervisory and control unit (also known as the
Rack Management System), such as the Avocent UMG, for system operation.
5. Observe the status of the indicators located on the SCC controller, rectifiers modules, and BBU modules. If
the system is operating normally, only the green LED will be illuminated for the rectifier modules and the SCC.
The BBU LED’s will be as follows if the ambient temperature is below 22 °C. The red LED can be illuminated
for up to 30 minutes due to an initialization period and the yellow LED should be illuminated during this