Vertiv™ NetSure™ HVT F02 CK1 Power System User Manual
34
Insulation information
Insulation menu mainly displays insulation status of main circuit and branch circuit, and resistance value of positive/negative
busbar to earth. See Figure 3.12.
Figure 3.12 Insulation information screen
Main Bus:
P-G: 500K
N-G: 500K
State: Normal
Branch: 1/8
P-G: 500K
N-G: 500K
State: Normal
History alarm screen
At screen in Figure 3.9, press
▲
or
▼
to select the ‘History Alarm’ menu, then press the ENT key to confirm.
1) If there is no history alarm, the system cannot access the history alarm screen.
2) If there is an alarm, the display shown in Figure 3.13 will appear.
Figure 3.13 History alarm screen
090123 07:58:33
Alarm: 1/95
Temp1 DisCon
090123 08:02:49
The history alarms of the controller are stored in cyclic order. At most 200 alarms will be recorded, above that, the earliest alarm
will be cleared automatically.
2. Press
▲
or
▼
to view other history alarms.
3. At any history alarm screen, press the ESC key repeatedly to return to the higher-level menu, and ultimately return to the first
system information screen.
Settings screen
Displayed in many screens, the settings screen is a sub-menu of the main menu. It is used to set system parameters. The settings
screen has password protection, only the correct password allows you to enter it. See Figure 3.14 for the settings screen.
Figure 3.14 Settings screen
Insul set
Settings
DC set
Sys set
1. At the main menu screen, press
▲
or
▼
to select the ‘Settings’ menu and press the ENT key to display the password
confirmation screen.
2. Input the correct password and press the ENT key to enter the settings screen. Press
▲
or
▼
to enter the operation screen
you need.
There are three parameters for setting: DC setting, insulation setting, and system setting. Setting methods are as follows:
DC setting
1. At the settings screen, press
▲
or
▼
to select the ‘DC set’ menu. Then press the ENT key to confirm, as shown in Figure 3.15.
