Vertiv™ NetSure™ HVT F02 CK1 Power System User Manual
28
Controller of the system parameter query methods: entering ‘Main
–
Random device
–
Samp’ view
Note: random device including: AC, Rectifier, Battery, Insulated, DC, system, other and the ‘list’ sub menu of the device under the
above submenus.
For the parameter query method, refer to
M822E Controller User Manual
for more information
.
Check Item
Ok
Comments
The controller should display the correct AC voltage. The difference between the displayed voltage and that measured at
the busbar with should be less than ±5V (The AC power supply is in normal status without harmonic interference)
The controller should be able to display the DC voltage. The difference between the displayed voltage and that measured
at the busbar with should be less than 1%
The controller should display the battery current. The difference between the displayed and measured battery current
should be less than 1%
Check the number of the rectifier through the controller. The number should be consistent with the actual number
Check the voltage, current, current limiting point of rectifiers through the controller. They should agree with the actual
parameters
For the system configured with temperature sensor, the controller should be able to display the battery ambient
temperature. Hold the probe of the temperature sensor with hand and watch the controller, which should display the
change of temperature
2.5
Final Steps
Check Item
Ok
Comments
Disconnect all test equipment from the power system and make sure that materials irrelevant to the equipment have
been all removed
Restore the power system to its original condition and close the cabinet door
Check and hand over the spare parts that the user has purchased
Note down all the operations taken, including time of the operation and name of the operator
NOTE!
Even if the system disconnects all AC inputs and battery inputs, the rectifier capacitor still needs to discharge for
a period of time. After measuring the DC bus voltage is below the safety voltage by a multimeter, then you can maintain
DC bus and device connected to the DC bus.
If any defect is found in this equipment, inform the personnel responsible for the contract.
If repairing is needed, please fill in the FAILURE REPORT and send the report together with the defective unit to the repairing
center for fault analysis.
