Vertical SBX IP 320, Руководство по установке

Страница: 69 / 148

SBX IP 320 Installation Guide
Chapter 6
Starting the SBX IP 320
Before Starting the SBX IP 320
In preparation for programming, perform the following steps:
1. The DIP switch (SW2) should be turned ON prior to installing the MBU to protect the
System data in case of power failure.
2. Check the DIP switch (SW1) of the MBU to All ON.
3. Plug the AC power cord into the SBX IP 320 System and AC outlet.
4. Program the Nation Code (PGM100) as applicable.
5. Reset the SBX IP 320 System.
6. Set the 4th pole (SW1) of the MBU to OFF when the System operates normally, to
protect programmed features after System power-up and initialization.
Basic Programming
The SBX IP 320 System can be programmed to meet an individual customer's needs. There are
two ways to perform Admin Programming:
• PC Admin - Refer to the PC Admin Programming Manual
• DKT - In this manual, DKT (Station 100) Admin Programming is described.
DKT Programming
All programming is done at one station (Station 100, Station Port #00, by default) using the
7224D Digital Key Telephone.
Additional programming stations may be assigned (113 - FLEX 1), but only one DKT can be
active in the programming mode at any one time.