S
UB
-A
UDIO
S
ET
M
ODE
(
P
ROGRAMMING
THE
CTCSS T
ONE
F
REQUENCY
/
DCS C
ODE
)
You may change the CTCSS tone frequency or DCS code which is memorized in the operating channel, if you desired.
1. Turn the radio “off” by rotating the top panel’s
VOL/
PWR
knob fully counterclockwise (into the click-stop).
2. Press and hold in the
PTT
switch and [
SIDE 1
] key;
while holding it in, turn the radio “on” to enter the
“Sub-Audio Set Mode”. The radio sounds “Tone A”.
During the “Sub-Audio Set Mode”, the LED indica-
tor on the top of the radio will glow “Yellow”.
3. Rotate the top panel’s
CH
selector knob to select the
channel where you want to change the Sub-Audio.
4. Press the
PTT
switch to decide the channel. The radio
sounds “Tone B”.
If the selected channel is vacant, the radio will sound
Error Beep (Tone C).
5. Rotate the top panel’s
CH
selector knob to select chan-
nel position equal to LSB (1’s place) of tone Table.
Ch1=1, Ch2=2, ............. Ch9=9, Ch10=0
When the channel position indicates the preset Sub-
Audio, the radio will sound “Tone G”.
6. Press the
PTT
switch to decide the LSB, the radio will
sound “Tone D”.
If the “Ch11” - “Ch16” is selected, the Sub-Audio will
be disabled. The radio sounds “Tone F” and the Sub-
Audio Setting of current channel will be finished. In
this case, if you want to change Sub-Audio for an-
other channel, repeat the step 3.
7. Select channel position equal to MSB (100’s and 10’s
places) of tone Table.
Ch1=1, Ch2=2, ............. Ch9=9, Ch10=10,
Ch11=11, ............. Ch15=15, Ch16=16
When the channel position indicates the preset Sub-
Audio, the radio will sound “Tone G”.
8. Press the
PTT
switch to decide the MSB code, the
radio will sound “Tone E”.
The table number “164” to “169” will become No-
Tone Setting. (If No-Tone is needed on the channel
then it is recommended to set LSB as No-Tone.)
9. Press the
PTT
switch again to finish the Sub-Audio Set-
ting of current channel. The radio will sound “Tone E”
10. The Sub-Audio Setting of current channel will be fin-
ished. If you want to change Sub-Audio for another
channel, repeat steps 3 - 8.
11. To end of the “Sub-Audio Set Mode”, turn the radio
“off” or press and hold the [
SIDE 1
] or [
SIDE 2
] key.
12. Turn the radio “on” again, the radio will reset and re-
start. The radio will sound “Tone H”.
Page 12
English
Содержание VX-351-EG3J-1
