20306741
30
BLDV7 Series Gas Fireplace
FINAL INSTALLATION
ROCK WOOL PLACEMENT
1. Place rock wool on burner to provide glowing
embers. For best results, pull the rock wool apart
into pieces the size of a dime or smaller.
2. Distribute one layer of rock wool to cover the burner.
Figure 49
3. Place the logs on the burner. Refer to
Log Place-
ment
below. Light unit and after 15 minutes, check
burner flame and glow. Refer to
Burner Flame
, in the
Cleaning and Maintenance section of this manual.
If the flame is blue and only in the center, turn off unit
and let cool. After unit cools, remove logs. If the back
holes are clear, add more rock wool to the center of the
burner. Replace logs and check flame again. Save left
over rock wool to refresh when cleaning later. Too much
rock wool can disturb the flame and cause sooting on
the glass or logs.
HEARTH BRICK PLACEMENT
Place the hearth brick centered in front of burner and slide back until it hits the stops on the right
and left of burner.
FP2340
BDVL base
Figure 39 -
Placement of Rock Wool on Burner
Cover with
Rock Wool
Burner
FP2340
LG648
BLDV ember place
WARNING
Do not use the entire bag of rock wool to cover the
burner. This could cause the flame to burn poorly and
may lead to sooting.