28
CDVZ Series Direct Vent Gas Fireplace
20014621
Only glass approved by Vermont Castings
Group should be used on this fireplace.
The valve access panel
is removed by lifting the
panel vertically and pulling
it away from the appliance.
(Fig. 61)
•
The use of any non-approved replacement glass will
void all product warranties.
•
Care must be taken to avoid breakage of the glass.
•
Do not operate appliance with glass front removed,
cracked or broken.
•
Replacement glass (complete with gasket) is
available through your Vermont Castings Group
dealer and should only be installed by a licensed
qualified service person.
Clean glass after first two weeks of
operation.
Do not clean glass when hot.
Do not use abrasive cleaners.
Do not strike or slam the glass.
Operating Instructions
Glass Information
Window Frame Assembly Removal
1. Turn the fireplace OFF (including the pilot)
2. If the unit has been operating allow time for the
components to cool.
3. Remove the lower panel door. (Fig. 61)
4. Release the two clamps securing the lower edge of the
window frame assembly by pulling down on the handles.
(Fig. 62)
5. Tilt the window frame assembly out slightly at the bottom,
lift the window frame assembly up and away from the
fireplace.
6. To replace the window frame assembly reverse the
procedure.
Glass Cleaning
It is necessary to periodically clean glass. During start-up
condensation, which is normal, forms on the inside of the
glass. This condensation causes lint, dust and other airborne
particles to cling to glass surface.
Also initial paint curing may deposit a slight film on the
glass. It is therefore recommended the glass be cleaned
two or three times with a non-ammonia based household
cleaner and warm water (We recommend gas fireplace
glass cleaner) within the first few weeks of operation.
After the initial cleaning process the glass should be cleaned
two or three times during each operating season depending
on the environment in the house.
Valve Access Panel Removal
Valve Ac-
cess Panel
FP2377
Fig. 61
Remove lower panel.
FP1228
remove glass frame
11/02
Lower Clamps
Window
Frame
Assembly
Push
Clamp
Handle
Pull Clamp
Hook
Window
Frame
Assembly
FP1228
Fig. 62
Window frame assembly removal.
WARNING
!
HOT GLASS WILL
CAUSE BURNS.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
AVERTISSEMENT
!
Un panneau vitré chaud
peut
causer des brûlures.
Laissez refroidir le panneau
vitr
é
avant d’y toucher.
Ne laisser jamais
les enfants
toucher le panneau vitr
é
.
FP2377
panel removal
4/09
1
2
