OWNER’S MANUAL
21
VERLINDE reserves the right to alter or amend the above information without notice
11/2018
Fastening the rope
On the first rope clamp
On the second rope clamp
Identify using the photos above.
If necessary, remove the limit switch.
Loosen the screws.
Insert the end of the rope between the drum flange and the cable clamp.
Tighten the screws.
Check that the rope is securely clamped.
Reassemble the limit switch.
The rope should never form a loop.
Important: the direction of rotation of the drum depends on how the machine is connected.
Winding the rope on the drum:
Reminder
: the maximum capacity of these winches varies on each model (see section §6.3).
Very important
: The safety regulations require that 3 whorls of rope always stay on the drum. To
comply with the legislation, the rope diameter must not exceed 7 mm for the TIRLIFT 2 250/350/500
or 12 mm for TIRLIFT 2 600/800/990/1500. If the rope and the hook used were not supplied with the
machine by the manufacturer, check that they guarantee a level of safety corresponding to coefficient
5.
Winding the rope on the drum:
to do this, tension the rope and wind it with joined strands onto the
drum. Check the direction of rope winding according to the three-phase connection.
Start to wind the rope forming a spiral to the right.
