Vantage 5000
1.4v-09.2019
15 | Page
5.2.2 Installing Continuous Tube
[
Ensure the Vantage 5000 pump is turned
off using the ON/OFF switch on the back
of the pump, if not, the rotor cannot be
turned by hand.
1. Open the pump door and push down the
tube clamp.
2. Insert the tube.
3. Rotate the rotor assembly using the ver-
tical guide rollers in a counter-clockwise
direction.
3. Place the tube behind the vertical guide
rollers and continue to turn the rotor as-
sembly in a counter-clockwise direction.
4.
When performed correctly the main
rollers will compress the tube.
5.
Release the tube clamp to lock the tube.
6. Push up the lower tube clamp and insert
the tube.
7. Once the tube is in place, close the pump
door before switching on the power sup-
ply.
Figure 6.1 Installing Continuous Tube
1
2
3
4
5
6
u
Isolate power supply from the pump before opening the
pump head.
u
Make sure the tube is compatible with the rotor assembly.
u
Before using a new tube assembly, make sure the pump is
run in the counter-clockwise direction for 1 minute.
DANGER
CAUTION
