Page 57 of 65
1. Locate the motion sensor connector at the rear of the camera. The holes for inserting the sensor wires
are labeled 1 through 4 from left to right.
2. Use a small screwdriver to depress and latch down the orange tabs over holes 1, 2 and 4.
3. Insert the red wire into hole #1 until the insulation just reaches the back of the camera.
4. Use the screwdriver to press down and release the orange tab above hole #1 locking the wire in place.
5. Repeat steps 3 & 4 for the white wire (hole #2) and the black wire (hole #4).
The sensor is ready for use with the camera. Reconnect the power supply to the camera and turn the
camera on. Refer to
Section 3.3: Camera Configuration
of the User’s Guide for help configuring the
camera to work with the sensor.
Notes:
1. The range of the sensor is approximately 15 to 18ft.
2. There is a red LED behind the sensor lens which lights when the sensor is activated.
Wire Color Chart
Connector #1
Red
Connector #2
White
Connector #3
Not used
Connector #4
Black
Содержание Wireless Observer
Страница 1: ...Page 1 of 65 Rev 01 14 2003...
