Ventis ME150, Инструкция по установке и эксплуатации

Страница: 27 / 32

ME150 - Installation and Operation Manual
27
6 MAINTENANCE
1. Clean color trim with soapy water and a soft cloth. Do not use any metal polish or abrasives.
2. Keep the glass relatively clean. Dirty windows will make the fireplace overheat. Wait until the glass is
cool before attempting to clean it. Wash the glass with window or oven cleaner, dishwashing liquid or
just soap and water. Spray the cleaner on a soft cloth and not on the glass, since overspray may
discolor coating or metal plating (not covered by the warranty).
DO NOT use steel wool, soap pads
(S.O.S.) or any other abrasive product since these may scratch the glass.
3. To remove the ashes, lift the log support. Put the ashes in a metal container with an airtight lid. Place
the container on a non-combustible surface away from any flammables until the ashes are cold.
4. Before each heating season, inspect the interior and exterior of the fireplace and chimney for any
defects or deterioration.
5. To reduce the risk of chimney fires, keep it relatively clean and regularly check for creosote buildup. To
open the rain cap, just unscrew it counter-clockwise. Any layer of creosote greater than 1/8” (3 mm)
thick should be swept. Use a plastic brush to avoid scratching the flue.
6.1 Replacing Glass
Do not use the fireplace with a cracked glass.
1. Cut the silicone joint holding the broken glass to the frame.
2. Remove all debris from the frame.
3. Use only 3/16” (5 mm) ceramic glass.
4. Slide the new window into the frame and fasten it in place with temperature-resistant silicone.
5. Handle the glass with care to avoid injury.
6. Allow to dry for 24 hours.
NOTE: Never use substitute parts. Use only Ventis brand parts.
6.2 Replacing Firestone in a ME150 Fireplace
Do not use the fireplace with a broken or missing firestone.
1. Remove the front stone (VA2-071-5).
2. Remove the upper deflector (PL60004) holding the side wall stones in place.
3. Remove the log support by pulling on it until it comes free.
4. Remove the floor stone (VA2-071-4).
5. Remove one of the side wall stones (VA2-71-3 or VA2-071-2).
6. Remove the second side wall stone while holding the back stone in place (VA2-071-1).
7. Remove the back stone (VA2-071-1).
8. To reinstall the replacement firestones, just follow the steps in reverse.