MA-SE-DCT3-01-02 Manual Doge CT3 eng rev2
Rev.4 Pagina 17 di 17
No. of pressures
0
1
2
3
4
5
6
7
8
9
10
11
Time settled
5 s
15 s
30 s
45 s
1 min
2 min
3 min
4
min
5 min
10 min
15 min
20 min
Temporized Output
For example, for obtaining an activation time of 30 seconds it is necessary to push the button twice.
Then, after 3 seconds without pressure of button, the receiver exits from TEMPORIZED setting mode.
At exit from the mode, the number of pressures is visualized by the same number of changes of LED from red-green color to the
color relevant to the settled output.
Maximum number of settable time is 20 minutes which is 11 pressures of button.
Exit from setting mode of output
If button is pushed during the three quick blinks which indicate TEMPORIZED mode, the receiver goes back to normal working
state without any change on behavior of output
Memory removal
For removing all transmitters from memory, at the fifth pressure (removal phase) keep pushing the button for 3 seconds during
red-green blinking until red-green LED switches on steadily. Then you can release the button.
When red-green LED switches off the memory has been deleted and all outputs are settled on MONOSTABLE mode.
For removing only one transmitter: at the 5
th
pressure, push the button of transmitter that you want remove.
NOTE:
Maximum number of acquirable transmitters: 50
Activation of output
Activation of outputs is signalled by switching on of relevant LED: LED1 is green indicates activation of output relay 1; LED1 red
indicates activation of output relay 1; LED1 red and green indicates that both outputs are activated.
The same happens for outputs 3 and 4. LED2 is green indicates activation of output relay 3; LED2 red indicates activation of
output relay 4; LED2 red and green indicates that both outputs are activated.
If the range of transmitter decreases considerably, the battery is probably discharged: change the battery.
N.B.
Danger of explosion if replaced battery is not of approved type. For battery disposal, please follows the guidelines of your country.
Venitem declares that this transmitter and receiver conform to the standards and regulations relevant to Directive 1999/5/CE.
Conformity Declarations can be consulted on website www.venitem.com. All necessary radiofrequency test were performed.
Warranty: All Venitem products are granted for 24 months.
With the aim of improving the design and the quality of the products, the company Venitem reserves the right of modifying the
product without previous notice. All faulty pieces must be returned to the Supplier.
Via del Lavoro, 10 - 30030 Salzano (VE) Tel. (+39) 041 5740374 – Fax (+39) 041 5740388 Web site www.venitem.com E-mail [email protected]
