MA-SE-DCT3-01-02 Manual Doge CT3 eng rev2
Rev.4 Pagina 11 di 17
INSTALLATION GUIDE with all DIP SWITCHES in OFF POSITION
YES
YES
YES
YES
NO
NO
Use the dedicated cable to connect the remote control receiver,
then set keys A and B (
Pict. 7
and
Guide to VELA remote control
setting
)
Connect zones 1, 2 and 3 to the detectors (
Pictures from 2 to 5
)
Connect the 24h line in series with the tamper of all devices
Connect the battery to the dedicated FASTONS and the power
supply to power supply connector J1
Push A button of the remote control several times, until the front
LEDs start flashing
Is the anomalies LED off?
Do the front LEDs flash for 1 minute?
Does the tamper LED
make 5 flashes?
Put zone 2 in alarm status
Do the front LEDs make 2 flashes and then a pause
AND does the loudspeaker sound at low volume?
Push A button of the remote control twice
Front LEDs flash for 1 minute
If the 24h line
and the zones
are not used,
connect them to
the ground
Tamper LED
turns on steady
NOTE: the KIT
does not require
it since it is
already set
NOTE: in case of
KIT, just check the
connection to AC
(230V)
Solve the anomalies. See
chart 3
The control panel is
armed, in OUTPUT
and in Walk Test
The cover is open,
which is the only
tamper noticed
Tamper LED makes 4 flashes
Check zones
connection
Push A button of the
remote control twice
NO
NO
The control panel
has been disarmed
and armed again
in Walk Test mode
See the scheme here below for the final
test
