Programming Manual
GLASSFRONT VENDING MACHINES
Rev. 1.12
MODELLS: G-DRINK SVE GF6 / GF9 – DR6 / DR9
Page 10 of 42
DRUM ERROR LIST
OPEN
Open position missing,motor or switch close position missing
CLOSE
Close position missing,motor or switch close position missing
LOCK
locking error ,motor or detection switch missing
UNLOC
Unlocking error ,motor or detect switch missing
DETEC
Product detection error
These potential errors will be NOT automatically cleared at the door closing,
manual clearing is required.
DOOR SWITCH ERROR ROUTINE
If the ENTER button is activated at the "DOOR" prompt the VMC will display a "DS"
message indicating a door switch error was detected (door open for more than one hour).
If the ENTER button is pressed and held for two seconds during the display of any error
code, that code will be cleared.
After clearing VMC will display the next existing error or "NONE" if no other error.
Activation of HOME button will return the VMC to the code level at the "ERROR"
message.
Be careful if door switch doesn’t work the cooling system is disabled!
SELECTION SWITCH ERROR ROUTINE
If the ENTER button is activated at the "SEL" prompt the VMC will display a "SLXX"
message where "XX" indicates the first selection switch error (switch always close).
Using the UP and DOWN buttons will cycle through all selection switch error. If the
ENTER button is pressed and held for two seconds during the display of any error code ,
that code will be cleared.
After clearing VMC will display the next existing error, or "NONE" if no other error.
Activation of HOME button will return the VMC to the code level at the "ERROR"
message.
CHANGER ERROR ROUTINE
If the ENTER button is activated at the "CHAR" prompt the VMC will display a "CC"
message indicating a changer communication error a "TS" message indicating a tube
sensor error, an "IC" message indicating an Inlet chute blocked error (no coins sensed in
the acceptor for a supplier pre-determined number of hours, a "TJ" message indicating a
tube jam error, or a "CRCH" message indicating a changer ROM checksum error. Using
the UP and DOWN buttons will cycle through all changer error. If the ENTER button is
pressed and held for two seconds during the display of any error code, that code will be
cleared.
After clearing VMC will display the next existing error, or "NONE" if no other error.
Activation of HOME button will return the VMC to the code level at the "ERROR" message.
