Programming Manual
GLASSFRONT VENDING MACHINES
Rev. 1.12
MODELLS: G-DRINK SVE GF6 / GF9 – DR6 / DR9
Page 17 of 42
MACHINE CONFIGURATION SETTING ROUTINE (protected menue)
If the ENTER button is activated at the "CON" prompt the VMC will enter the machine
configuration setting routine. The display will show a "C1" message where the "1"
indicates configuration setting number 1. Using UP and DOWN button will cycle through
the available configuration setting numbers. Activation of the ENTER button while a
configuration setting number is displayed will allow access to the current setting number of
the displayed configuration setting.
Activation of the ENTER button will save the displayed configuration.
Activation of the HOME button while configuration is displayed, without doing an ENTER
before, will return the VMC to the "CON" display without saving the displayed
configuration. Activation of the HOME button returns to unprotected area.
C1
RESERVED FOR FUTURE USE
C2
SLAVE UNIT ENABLE
(Only with Master & Snack Slave software)
This parameter enables or disables the slave unit and related programming menu:
C2 = 0 Slave machine not installed, normal menu.
C2 = 1 Slave machine installed, extended menu aktiv.
C3
EXTRA ROTATION FOR SNACK SLAVE UNIT
(Only with Master & Snack Slave software)
This parameter is used to activate an extra rotation of the spiral if the product is not
detected by the optical barrier:
C3 = 0 Extra rotation disable.
C3 = 1 Extra rotation enable.
C4
OPEN DOOR DISPLAY MODE
This parameter is used to change the MIS data information that you can read when the
door of VMC is open:
C4 = 0 Display only the Existing Error or nonE
C4 = 1 Display total Sales, total Cash and Existing Error or none (default).
