Vega VEGAWAVE 63, Руководство по эксплуатации

Страница: 27 / 40

2
1
F ig . 16 : L oosen the screws
1 E lectronics module
2 S crews ( 2 pcs .)
6 R emove the old oscillator
7 C ompare the new oscillator with the old one . T he type label
of the oscillator must correspond to that of the old
oscillator . T his applies particularly to instruments used in
hazardous areas .
8 C ompare the settings of the two oscillators . S et the
adjustment elements of the new oscillator to the same
setting of the old one .
I nformation :
M ake sure that the housing is not rotated during the electronics
exchange . O therwise the plug may be in a di ff erent position
later .
9 I nsert the oscillator carefully . M ake sure that the plug is in
the correct position .
10 S crew in and tighten the two holding screws with a
screwdriver ( T orx size T 10 or P hillips 4 )
11 I nsert the wire ends into the open terminals according to
the wiring plan
12 P ress down the opening levers of the terminals , you will
hear the terminal spring closing
13 C heck the hold of the wires in the terminals by lightly
pulling on them
14 C heck the tightness of the cable entry . T he seal ring must
completely encircle the cable .
15 S crew the housing cover back on
T he electronics exchange is now fi nished .
VEGAWAVE 63 - - NAMUR 27
M aintenance and fault recti fi cation
32259
-
EN
-
070117