VeEX UX400, Руководство пользователя

Страница: 79 / 209

CIR Test Configuration
CIR Test Config.:
Select Simple Test, Step Load Test, or Simple and Step.
Simple Test:
Starts the tests at the CIR.
Step Load Test:
Starts the test below the CIR and continues in steps until it reaches the CIR.
Simple and Step Load Test:
Step Load Test performs only if the Simple Validation test fails.
Tap on the
Test Duration
box to input a test duration (test duration must be less than 999 sec).
Tap on the table to modify the CIR value percentage for each step.
CIR Test Config
Go back to top Go back to TOC
6.4.1.1 Header Settings
Service #:
Select a service to configure
Service Name:
Assign a name to the service if desired.
Frame Type:
802.3 Raw or Ethernet II (DIX)
Frame Size Type:
A fixed frame size is chosen as default
Frame Size:
Input a fixed frame size within the range of 64-10000 bytes.
Please see 6.3.1 RFC 2544 Setup and follow the setup procedure to configure the remaining Header Settings for V-SAM.
V-SAM Setup - Services - Header Settings
UX400 10G e-Manual D07-00-058P RevA00 Page 79 of 209