EMR3 Truck Installation
C&C Mode Switch Options
23
Encoder mounting base as shown in Figure 18. Slide the bushing into the cord grip and then screw the cord
grip nut onto the cord grip and tighten securely.
Attach the shield of the temperature probe cable to a grounding lug on the Pulse Encoder mounting base.
5.
Attach each wire (no polarity) of the 2-conductor Temperature Probe and/or ESS switch cable(s) as shown in
Figure 18.
6.
Tie wrap the IB, ESS switch, and temp probe (if installed) cables to the Pulse Encoder mounting base.
7.
For Transfer Interlock applications, attach the 2-conductor cable from the switch as shown in Figure 18.
8.
Replace the Display Head cover and screw in the four cover retaining bolts just enough to hold them in (the
cover will be removed later for system calibration).
9.
Using the tie wraps from the installation kit, attach the 4-wire cable from the Display Head to the Interconnect
Box along the inside of the truck frame, to existing piping, or to the reel motor cable back to the cab. Avoid
sharp bends and placements where vibration might wear through the cable. Allow ample cable length to
compensate for tilt-cab trucks and to avoid putting additional stress on the assembly. Running the cable
through a split loom or tubing will offer added protection from weather and abrasion. Use a rubber grommet or
cord grip to line the hole where cable passes through truck cab wall or floor. Tractor-trailer installations will
require detachable plugs, and either a separate tensioning device much like that used to protect air lines, or
perhaps you can attach the cable to one of the existing air lines with tie wraps.
C&C Mode Switch Options
There are two C&C mode switch configurations:
1.
A C&C wire jumper (see Figure 18) - configuration. To enter C&C mode, you remove one end of the jumper
from its terminal, and you reconnect it when finished.
2.
A C&C corner switch assembly which fits into a corner of the Display Head’s housing (P/N 846000-018). To
enter C&C mode, you remove the corner bolt of the Display Head’s cover that presses against the switch
actuator lever, and you replace the bolt when finished (see Figure 19).
Содержание EMR3 XStream-PKG
Страница 1: ...Manual No 577013 758 Revision I Installation Guide EMR3 ...
Страница 29: ...EMR3 Truck Installation C C Mode Switch Options 24 Figure 18 Display head cable connections ...
Страница 67: ......
Страница 68: ...For technical support sales or other assistance please visit www veeder com ...