64
6.26 CUTTING BOARD
6. Installation of details
Cabinets delivered before 2017 have the following potential to
install a cutting board afterwards.
Partition strips in cabinets with widths of 300, 400, 500 and
600 mm are designed for
CUTTING BOARDS.
Saw with a jigsaw
according to the thick line in the top image. Pull out the remaining
pieces with pliers. Secure the runners and clean away any residual
glue so that the cutting board can move freely.
6.27 SEALING THE BOTTOM COVER
In sink cabinets with a solid bottom and solid back, the aluminium bottom cover must be sealed in the joints against the side and back
of the cabinet using silicone thread. In cabinets with drawer runners, it is possible to seal outside the drawer runner; alternatively, the
drawer runners can be unscrewed and the bottom cover sealed against the sides of the cabinets, then the drawer runners can be screwed
in again. Supplement with sealing kit containing glue and ducts. A pipe transit for the dishwasher’s connections is also available as
an accessory.
Other sink cabinets are designed with a 120 mm deep installation
opening, where the bottom is recessed and has an aluminium bottom
cover. The cabinets do not have a back against the wall to facilitate
screw attachment of pipe clamps, valves and other accessories for the
installations. This type of sink cabinet has floor protection, a sealing
kit, an edge clamp and a water safety system.
These are sold as accessories.
SILICONE
120 mm