18
1.12 INSTALLING PLINTHS
1. Installing base and tall cabinets
The plinth under the front of the cabinets is locked against the plinth leg by
placing
CLIPS 39205
on the top edge of the plinth. These clips then lock the
plinth onto the supporting legs.
Mitre the plinths together or use corner strip 3815 which is glued in place, or plastic strip white 38035. Joint strips
are also available in thin aluminium, white 38025 and colour 38026.
Fit
PLINTHS 3862
: begin with ends where metal
END CLIPS 392051
are pressed into the ends of the plinth and
folded in towards the supporting leg. Also fit plinths at ends by the hob or dishwasher.
A PLASTIC PLINTH WITH STAINLESS LOOK 3863
is
equipped with a clip fitted in the groove on the inside of the
plinth and then snapped into place on the supporting legs.
Equip the plinth with suitable corner, joint and end strips.
In the case of an integrated dishwasher, you may need to cut out the kick plinth to guarantee the operation of the
dishwasher door. In this case, you are recommended to apply a sealing lacquer, such as Vedum sealing lacquer, on
the sawn edge.
Place the plinth under the cabinets against the supporting legs and pull the visible
part of the clip towards the supporting leg until the clip locks into the plinth
attachment. Once all the clips have been locked in the plinth leg attachment,
check that the plinth is secure.
Joint strips
38012