VCommand VControl, Руководство пользователя

Страница: 11 / 18

21
Call Function
The CALL command is used to dial pre-stored
phone numbers from your PhoneBook. The system
is capable of saving up to 32 names, each with four
different phone numbers. Please refer to the
PhoneBook section to learn how to program
numbers and locations.
“
Ready” <Beep>
Call Î “ Name Please” <Beep>
Speak the Name of the Person [must have
been previously stored in the PhoneBook] ***
Î Name is re “ Please say a location” +
Lists Stored Locations ** <Beep>
Speak Desired Location Î Name + Lo
“ Is this Correct? ” <Beep>
Yes [If it is correct] Î “ Dialing” and the Call is
connected
No [if any of the information is incorrect] Î
“ Would you like to try again? ” <Beep> [If No
the system returns to the Main Menu]
Yes Î “ Please Say a Location ” + Lists Stored
Locations <Beep>
Speak Desired Location
Î
Name + Lo
“ Is this Correct? ” <Beep>
Please note that the numbers are stored in the car
kit and not in the cellular phone. The numbers
stored in your phone are not directly accessible
but can be retrieved using the
button. See
the chapter on Special Functions to learn more
about this capability.
**
If the requested name has only one location
stored, then the system will not ask for a location
but jump to confirming that the name and location
are correct. If you respond
No to this prompt, it
will immediately return to the main menu since
there are no other locations.
*** If you select a name not in the PhoneBook, the
system will prompt you [up to three times] with
“
Name Please” <Beep> If after three attempts, a
match is still not found, then the prompt, “ Name not
found in the PhoneBook. Would you like to try
again?”
<Beep> If you answer Yes then the
process will start over again. If you answer No,
then the system will return to the main menu.
Call Waiting
The unit will <Beep> when a call is active and an
incoming call is detected. The unit supports several
options with regards to Call Waiting.
The Redial Function
The Redial command is used to place a call to the
same number that was previously called.
Please note that the number called will be the
last one dialed from your cellular phone,
necessarily the last one called using the kit. If
you used your phone without the kit, it will use
that number as the last number dialed.
not
Active Call <Beep>
Press
to switch to the incoming call.
Press
for two seconds to end call and
switch back to the original call. Press
for
one second to switch back to the original call
without disconnecting the new call.
To connect both calls in a conference call, see
Chapter 7 – Special Functions – Conferencing.
“
Ready” <Beep>
Redial Î “ Dialing”
The Call is connected
22