Placing a Call – from the “Ready” Prompt
Dial Function
The DIAL function is used to dial a phone number
by providing the kit with a series of digits. You can
enter the number as either a complete string of 7, 10
or more digits or you can break up the phone
number into segments (referred to as blocks) and
the system will piece them together before dialing
(segment dialing). The following examples
delineate both methods:
19
20
Entire Number Dialing
“
Ready”
<Beep>
Dial
Î
“
Number Please”
<Beep>
Speak the digits of the phone number [e.g.
8-0-0-1-2-3-4-5-6-7]
Î
Number is re
“
Complete the Number, Say Clear or Say
Dial”
<Beep>
If the Number is Correct say
Dial
Î
“
Dialing”
and the Call is connected
If the Number is Incorrect say
Clear
Î
All
digits are cleared then <Beep> then
Repeat
the digits of the number
(there is no furth
prompt) – this cycle will continue until you get
a correct number or say
Cancel
to return to the
main menu.
er
Block Number Dialing
“
Ready”
<Beep>
Dial
Î
“
Number Please”
<Beep>
Speak the digits of the phone number from 1
to 10 digits at a time [e.g. 800]
Î
Number is
re “
Complete the Number, Say Clear or
Say Dial”
<Beep>
Speak the next sequence of digits [e.g. 123]
Î
Number is re “
Complete the Number,
Say Clear or Say Dial”
<Beep>
Speak the next sequence of digits [e.g. 4567]
Î
Number is re “
Complete the Number,
Say Clear or Say Dial”
<Beep>
If the Number is Correct say
Dial
Î
“
Dialing”
and the Call is connected
***
Special Note – You must speak one digit at a
time and not numbers ten or greater [e.g. eight
hundred, forty-five forty-five]