Vatech Green 16, Руководство по установке

Страница: 14 / 162

1. Introduction
6 Green 16/18 Installation Manual
Cautions for Installation

You must read and understand all instructions in this
manual before installing the equipment.

You must confirm that the system is installed according
to the instructions provided by this manual and perform
the appropriate procedures therein.

Before turning on the equipment, leave it a room
temperature for more than an hour

If the equipment has been stored at temperatures of
below 10
℃
(50
℉
) for more than a couple of hours,
allow the equipment to reach room temperature before
applying mains voltage

Installation and related work must be performed by
people authorized by VATECH.

DO NOT connect any items or equipment that is not
part of this system: IEC60601-1-1 (3rd edition: 2005).

Any equipment not approved by VATECH must comply
with the applicable standards: IEC 60950-1 (2nd
edition: 2005) for IT equipment (Ex: PC) and IEC
60601-1 (3rd edition: 2005) for medical electrical
equipment.

All operators of this equipment must ensure that all
requirements outlined in IEC 60601-1-1 (3 rd edition:
2005): Safety Requirements for Medical Electrical
Equipment are fully met for the safety of patients,
operators, and the environment.

DO NOT touch-sensitive areas such as the sensor
when installing the equipment. The touch-sensitive
areas are mentioned in relevant sections.

The use of wireless phones may interfere with the
operation of this equipment.

Use an ESD (electrostatic sensitive device) wrist band
to connect it to a ground wire when installing the
equipment.

Touch a ground point to discharge static electricity
before handling PCB boards.
Important Notes for Installation Site

The PC monitor, emergency cut-off switch, and X-ray
Exposure Switch must be located close to the operator