VAT 642 GP Series, Инструкции по установке, эксплуатации и обслуживанию

Страница: 35 / 113

Series 642 INSTALLATION
605593EC Edition 2017-11-24 35/113
4.6.4 Valve configuration
Basic valve configuration must be adapted according to application needs.
Definition of valve plate position in case of:
•
After power up, default is ‘close‘.
•
Power failure, default is ‘not defined‘. Only for versions that have Power Fail Option equipped [642 . .
- . . C . - . . . . or 642 . . - . . H . - . . . . ].
•
Network failure, for default settings refer to individual product data sheet.
Local operation:
(‘Control View’, ‘Control Performance Analyzer’
or ‘Service Box 2‘) Remote operation:
(Refer to chapter «Explicit messaging setup
commands» for details)
With CPA:
•
Do valve configuration in menu ‘Valve /
Setup’.
With SB2:
•
Do power up configuration in menu
‘Setup / Valve’.
•
Do power fail configuration in menu
‘Setup / Valve’.
1. Select POWER UP CONFIGURATION
2. Select POWER FAIL CONFIGURATION
4.6.5 Sensor configuration
Basic sensor configuration must be adapted according to application needs.
•
ZERO function: This may be ‘disabled’ or ‘enabled’. Default is ‘enabled‘. Refer also to chapter
«ZERO».
•
Sensor configuration for 2 sensors versions [642 . . - . . . Q - . . . .]. Refer also to chapter: «Pressure
control operation with 2 sensors».
Local operation:
(‘Control Performance Analyzer’ or ‘Service Box 2‘)
Remote operation:
(Refer to chapter «Explicit messaging setup
commands» for details)
With CPA:
•
Do 2 sensor configuration in menu
‘Sensor / Setup’.
With SB2:
•
Enable or disable ZERO function in menu
‘Setup / Sensor’.
•
Do 2 sensor configuration in menu ‘Setup
/ Sensor’.
1. Select ZERO CONTROL
2. Select SENSOR MODE
3. Select SENSOR RATIO