4
o
peratIon
of
the
mIxer
:
A)
Place the tool in the bowl. Open the safety guard
B)
Note: the bowl arms must be in the lowest position
.
Place the bowl in the bowl arms. Check that the bowl
is pushed right back into the arms and that the “centre
ear” of the bowl arms is facing the mixer
(fig. 3)
. Place
the mixer tool in the bayonet shaft. The tap of the tool
must be turned right into the bayonet hole. Close the
safety guard.
C)
Press to lift the bowl
(fig. 1)
. The bowl will auto-
matically stop in the top position.
D)
The mixing time can be set on the timer using the
and
buttons. The mixer stops automati-
cally when the mixing time has run out. (If the mixer
stops at high speed when the mixing time runs
out, follow the instructions
“Start-up after stop at
high speed”
before starting the mixer again).
You can also start the mixer without setting a time.
If you do not set a time, the display will function as
a clock that counts up. See also
“Timer function”
on page 5
E)
Start the mixer by pressing
(fig.1)
F)
Turn the speed selector lever
(fig. 2)
to the rear until
the required speed has been obtained, (notice the
recommended maximum speeds on page 3).
The speed must be changed only when the
mixer is running.
The mixer must not be started in high speed
when loaded.
Always change to low speed before using
or otherwise stopping the mixer
G)
During the mixing process the mixer can be paused
by pressing
(
first change to low speed
). You
can now lower the bowl or open the safety guard.
If you start the mixer again using
the timer
settings will be unchanged.
If you start the mixer using
the settings will be
reset. See also
“Pause function”
H)
Before the mixer is stopped, the speed selector lever
must be moved back to lowest speed
(fig.2)
. Stop the
mixer by pressing
(fig.1).
J)
When the tool has stopped rotating the bowl can be
lowered by pressing
.
p
ause
funCtIon
:
The mixer has a pause button
, which should be used
to stop and start the mixer in a process where the timer
is used.
•
Change to low speed
•
Stop the mixer using
. The timer will continue to
count downwards when you start the mixer again by
pressing
.
• When you stop the mixer pressing
you can lower
the bowl and open the safety guard. When you press
again, the timer continues to count downwards.
Emergency stop
Fig. 3
Mixer seen from
above
, the bowl has
been pushed all the
way into the bowl arms.
Notice: the centre
“ear” of the bowl is
facing the mixer
Fig. 2
Mixer with open
safety guard,
lowered bowl and
mounted tool.
First “ear”
Second “ear”
Centre
“ear”
Fig. 1
Operation panel.
Timer/
Display
Start/Stop
Time up
Time
down
Speed selector lever
Low
speed
High
speed
Before the mixer is stopped, the
speed selector lever must be
moved back to lowest speed
Pause
Bowl down
Bowl up
