Vari Hurricane F-530, Инструкция по эксплуатации

Страница: 22 / 37

Hurricane F-530
with leading wheel
22
6.8 Washing and cleaning of the machine.

Cleaning and washing the machine, proceed to observe valid regulations and
legislation on the protection of watercourses and other water resources against
pollution or contamination with chemical substances.

Never wash the engine with a stream of water! Electric equipment might fail when
starting the engine.
All dirt, debris and plant residues should be removed from the machine after the end of
the season. Check the intactness of working blade, sharpen cutting edges (or replace the blade
if necessary) and conserve them with conservation oil. Travel wheels should be dismounted
from the axle once in a season, cleaned and the hubs inside filled with a new filling of plastic
lubricant.

The engine must be switched off and the cable termination to the spark plug
disconnected!
Procedure of wheel disassembly, lubrication and re-assembly:
a) Underlay the machine so that the wheels can freely turn. The machine must be
secured against spontaneous motion.
b) Take out the split pin and screw the slotted nut out by using spanner No. 24. Remove
the wheel from the axis.
c) Clean the wheel hub inside, wheel hub flange with balls and the free wheel from dirt
and old grease.
d) Fill the hub inside with new grease (e.g. for water pumps) lubricating at the same
time also the flange with balls and free wheel surfaces.
e) Slide the free wheel on the wheel axis. The pin driven into the wheel axis must lean
against the inclined surface on the free wheel (see Fig. 10). Put the wheel onto the
axis, screw the nut to the stop; then release it by one split pin groove and secure the
connection with a new split pin. The wheel must be freely turning with no great axial
clearance.
f) Check of the correct free wheel assembly: Press the wheel drive clutch lever, turn the
driving wheel by hand in the direction of travel forward. The free wheel must be
clicking.
Split pin
Slotted nut M16
Washer
Ø 17
mm
Wheel 3.00-8“
Figure 11: Free wheel (on the left travel wheel, mirror wise on the right
wheel)
Shaft – Wheel axis
Spring
Free wheel
Pin