Vari Hurricane F-530, Инструкция по эксплуатации

Страница: 5 / 37

Hurricane F-530
with leading wheel
5
3 Operation safety.
3.1 Safety regulations.

This international symbol indicates important messages concerning safety. When you
see the symbol, be aware of a possible injury threatening to you or to other persons and
read the attached instructions carefully.

The machine operator must be over
18 years of age
.
He (she) is obliged
to get
acquainted with the instructions for use of the machine and is supposed to be informed
of the general principles of work safety.

Prior to carrying out any activities in the near vicinity of the machine, switch the engine
off and wait until the cutting blade stops moving! Before leaving the machine alone,
always switch off the engine!

Never let the engine running at maximum speed or idling for a long time with the
cutting blade and travel wheels drive clutch switched off! Components of the machine
drive (V-belt, belt pulley, clutch pulley, etc.) might get damaged!

Prior to each employment of the machine
, check its parts (working mechanism or its
casing in particular) for a possible damage or loosening. Defects must be rectified
without any delay . Repairs are to be made only with the original spare parts.

Before using the machine, the stand to be cut must be cleared of solid bodies such as
stumps, branches, stones, wires, loose construction debris, etc., which could be flinging
up or which might damage the machine. If these cannot be removed, avoid working in
such places.

The machine is equipped with a rotating working implement. Maximum
circumferential speed is
69,2 m.sec
-1
. Therefore, make sure that other persons move at
a safe distance from the machine when it is in operation with regard to a possible flying
away of the cut stand or flung out solid objects!

With respect to the exceeded recommended values of noise and vibrations, you are
warned to observe the following instructions when working with the machine:
a) Protect your hearing by using suitable protective aids specified in CSN EN
352-1
(shell ear protectors) or
CSN EN 352-2
(plug ear protectors). Require
the aids from your dealer.
b) Working with the machine should be interrupted after max. 20 minutes for a
minimum break of 10 minutes. During these breaks, the machine operator must
not be exposed to the impact of another source of noise or vibrations.

Machine operators should use working aids authorized to CSN EN 166 or CSN EN
1731 (tight-fitting garments, sturdy shoes, working gloves and protection glasses).
Keep a safe distance given by the handlebar.

Don’t start the engine in enclosed spaces! Pay increased attention when handling the
machine since the exhaust silencer remains hot after the engine has been switched off;
make sure there are no leakages and spills on engine parts when refuelling. If they
happen to occur, dry out the stained parts or wait until the petrol evaporates.