Vari Hurricane F-530, Инструкция по эксплуатации

Страница: 15 / 37

Hurricane F-530
with leading wheel
15

Be very careful while lifting the machine and driving back!
b)
Engine losing rotations and stalling
: release both levers on the handlebars, lift the
machine front by pushing down on handrails and move the machine slightly back.
Clean the space under the cutting blade space and spread the cut grass across the
ground surface. Start the engine, switch on the cutting blade drive (see
Chapter 6.3 )
and drive the machine against the sward again (see Chapter 6.4 ).

The engine must always be switched off when cleaning he space under the blade
cover!

Tilt the machine always only backwards onto the handlebars. Be very careful while
moving under the lifted machine! Secure the machine against its spontaneous
motion and tilt!

Be very careful while cleaning the space under the cutting blade cover. Cutting
edges of the blades are sharp. You should wear protective gloves or use a suitable
piece of branch etc.
6 Maintenance, care and storage.
To ensure a long-term satisfaction with our product, it must be given proper care and
maintenance. Regular maintenance of the machine will prevent its early wear providing at the
same time for a correct functioning of all its parts.
Prior to any machine use, check all bolts and nuts for their correct tightening. Make sure
that all safeguards are in good order. Check the blades, fixing bolts and individual elements
of cutting mechanism for a possible wear or damage. In order to keep a good balance of the
machine, worn-out or damaged blades and fixing bolts should be replaced with original spare
parts. All worn-out or damaged components should be replaced also for the reason of
machine safety. Oil level in 4-stroke engines must range within limits described in the
“Instructions for engine operation and maintenance“.
Follow all instructions concerning the intervals of machine maintenance and adjustments.
It is advised that you keep records on the number of machine working hours and on the
conditions in which the machine was working (for service purposes). The after-season
maintenance of the machine should be entrusted to one of our authorized service workshops,
the current maintenance as well if you do not trust your own technical skills.

Regarding the machine weight, all maintenance and adjustment procedures are to be
done by two persons.
6.1 Machine lubrication.
6.1.1 Gear oil change and replenishment.

When replacing oils, follow the basic hygienic principles, regulations and laws on
environment protection.
The gearing works in an oil bath. Oil volume should be checked once a month (oil plugs see Fig.
5).
Minimum grade of gear oil should be GL-4, GL-5 according to API, 90 or 80W – 90 according to
SAE.
Oil replacement in a new machine is to be made after the first 5 hours of operation and then after
100 working hours or after the end of the season. This will ensure that the gears will not suffer