Vari DSK-317.1/S, Перевод оригинальной инструкции

Страница: 30 / 44

VARI GLOBAL
2.8.3 Service intervals
Activity Interval in season After the season
Oil level check Perform the check as needed, or whenever the gearbox leaks. Check and eventual fill to the MAX imum level.
Clutch plate check
Each time the engine is mounted on the gearbox or 1x a month.
In case of visible wear check the clutch plate lining on the
driving unit. Check, cleaning and degreasing.
Cleaning the output shaft Clean the output shaft with a wire brush after each use.
Clean the output shaft with a wire brush.
Preservation - apply only a thin layer of anti-
corrosion oil.
Degrease the preserved surfaces of the output
shaft before the season!
Tightening of the screwed
connections
Check before each use.
In the case of wear (damage) replace the screw connection
with a new one. Use original connecting components. Tightening.
Cleaning of the connecting
flange
Each time the engine is mounted on the gearbox or 1x a month. Degreasing.
Removing dirt and debris After each use Yes.
Lubrication - See Table 23.
Table 24: Service intervals
2.8.4 Problems and their solutions
Problem Cause Solution
The output shaft is not
turning
no gear is engaged engage
the engine centrifugal clutch is slipping - degrease the gearbox clutch plate and check the
sealing of the gearbox and the engine crankshaft
- checking the integrity of the clutch lining
- visit the service workshop
faulty clutch plate mounting visit the service workshop
other defect visit the service workshop
During forward travel the
small one-axle tractor pulls
to the side
different tyre pressure check, inflate to the same pressure
too much grease under the head of the freewheel locking
finger clean and re-grease the freewheel hub
worn grooves of the freewheel hub visit the service workshop
Dysfunctional freewheel hub the locking pin of the finger does not move in its seat clean and lubricate
worn grooves of the freewheel hub visit the service workshop and parts replacement
the wheel hub slide assembly is dysfunctional dismantle, clean and lubricate;
in case it is not possible to dismantle the slide
assembly and it is seized it is necessary to visit the
service workshop and replace the parts
other defect visit the service workshop
Oil rises around the output
shaft damaged sealing rings visit the service workshop
Oil rises into the clutch plate
space
damaged packing under the clutch plate visit the service workshop
Other defect visit the service workshop
Table 25: Problems and their solutions
2.8.5 Storage
Prior to a long-term storage (e.g. after the season) clean the machine from dirt and plant residues. Prevent access of unauthorized
persons to the machine. Protect the machine against the climatic influences but do not use airtight protection to prevent higher corrosion of
the machine.
After the season we recommend that you have the machine prepared for the next season in one of our authorized service centres. Note
that before the season our service network is fully booked up.
We especially recommend:

To conserve all worn places on the working implement.

Remove from the machine all dirt and plant remains.

Repair all damaged places on painted parts.

Carry out lubrication of the machine according to the recommendation, see Table 23.
30
R
ev
iz
e
0
4
/2
0
1
5