Technical Manual: TM50567
Optica 30/40/50 series
Revision: 4.0
Date of release: 2019-01-23
39/56
www.vareximaging.com
OPERATING MODE:
This is the normal operating mode of the collimator. This mode is entered either through a
successful POWER ON (fully functional) or after accepting a fault condition (partly functional).
The color of the status LED is green. See §5.3 for more details about the functionality that is
available during OPERATING MODE.
ERROR MODE:
When a fault condition is detected, this mode is entered the color of the status LED is red.
Only applicable for Optica 40:
The collimator shows a message on the touch screen. The fault
conditions are indicated by a number and explained in §7.2.
(Figure only applicable for Optica 40)
NOTE:
only the first detected fault condition is displayed on the touch screen.
(not applicable for Optica 30)
NOTE:
It is important to send the following information to Varex Imaging
Nederland B.V. for analysis:
•
Error code. When the warning symbol close to the setup button is
displayed, the last displayed error message can be viewed again by
selecting the warning symbol.
•
Version of the main software; available on the
Service Screen 3
,
see this Technical Manual (§3.9).
•
Version of the display software, displayed on the touch screen
during power-on
(not applicable for Optica 30).
POWER-OFF:
There is no shutdown procedure for the collimator. The collimator can be switched OFF at any
time without damaging the collimator by switching OFF the power supply to the collimator.
