Technical Manual: TM50567
Optica 30/40/50 series
Revision: 4.0
Date of release: 2019-01-23
7/56
www.vareximaging.com
Symbols used in this document
To ensure adequate and clear understanding of the information provided in this manual, the symbols
listed below are used to indicate warnings, cautions, actions and notes that are important for correct
and safe use of the Collimator.
WARNING:
Warnings are directions which, if they are not followed, can cause fatal or serious injuries
to a user, engineer, patient or any other person or can lead to a mistreatment.
CAUTION:
Cautions are directions which, if they are not followed, can cause damage to the
Collimator described in this manual or any other equipment or goods and can cause
environmental pollution.
NOTE:
Notes provide advice and highlight unusual points. A note is not intended as an
instruction.
Advisory
This manual must be read and understood by the users as defined in the INTENDED USE (see
section §2.1) and SERVICE PERSONNEL.
This manual must be made available to the users and SERVICE PERSONNEL.
The users and service personnel must verify that all requirements according to the safety standards
and regulatory legislation are met before use of the Optica 30/40/50 series.
Host system marking and/or certification (e.g. CE-marking, NRTL certification, etc.) can be affected by
installation of the Optica 30/40/50 series. Please consult the manufacturer of the host system for
advice on installation of the Optica 30/40/50 series.
Information regarding accidents that have occurred using the Optica 30/40/50 series must be reported
to Varex Imaging Nederland B.V. immediately.
Varex Imaging Nederland B.V. is not liable if the provided instructions are not complied with. Varex
Imaging Nederland B.V. is not liable if one or more of the following cases apply:
•
Modification or repairing of the Optica 30/40/50 series in any way other than described in this
manual.
•
Installation of the Optica 30/40/50 series which is not in accordance with the installation
instructions as provided.
•
Use of the Optica 30/40/50 series other than the INTENDED USE.
•
Installation of the Optica 30/40/50 series by SERVICE PERSONNEL that is not qualified.
•
The Optica 30/40/50 series is not subjected to regular inspection and maintenance.
•
Use of the Optica 30/40/50 series in a way which could not be reasonable foreseen by Varex
Imaging Nederland B.V..
•
Direct or indirect damage which are caused by not following the procedures and instructions in
this manual.
Radiation danger
The Optica 30/40/50 series are designed and manufactured according applicable standards to meet
the safety legislation. However due to inherent radiation danger which cannot be eliminated, it is
crucial to follow all safety procedures and instructions. To minimize the inherent danger of radiation, all
procedures and instructions must be followed by the users and SERVICE PERSONNEL.
The user and SERVICE PERSONNEL must ensure that all possible measures are taken to ensure
health and safety of patient and user.
