Vante 4600, Инструкция по эксплуатации

Страница: 18 / 33

Vante
®
Model 4600
6
1.6 Seal Cycle
The Sealer “seal cycle” (or duty cycle) is defined as the time period, in seconds, between
consecutive, repetitive seals. The maximum seal cycle and hourly rate will vary with
different types and sizes of tubing, processing media and environmental conditions of the
facility. Operating the Sealer as fast as it allows is acceptable, however, if continuously
sealing, the Sealer may automatically shut down to avoid overheating. The green “seal
ready” light will remain illuminated but seals cannot be made. If this occurs, leave the
power on so the fan will continue to run. Allow five minutes for cooling, ensure the
green seal ready light is on, and resume sealing.
1.7 Specifications
Mechanical
Dimensions
Power Source:
10.5 L x 4.4 W x 7.1 H in.
(26.7 x 11.1 x 18.1 cm)
Operating weight
Power Source with cord:
9.6 lb (4.4 kg)
Hand Held Sealing head: 0.6 lb (0.3 kg)
Bench Top Sealing head: 5 lbs (2.3 kg)
Electrical
Power input 100-120/230 VAC, 50/60 Hz
Current draw 6.3A /4A INTERMITTENT
Mains AC power fuse 250VAC, 5x20mm T6.3A/T4A INTERMITTENT
RF power output 150 watts min into matched 50

load, at power-up
Primary frequency 40.68±0.02 MHz
Environmental Conditions
Installation Category I
Pollution Degree 2
4º-38ºC at 90 percent maximum relative humidity, non-condensing.
Altitude tested up to 2000 m.