Vanair Air N Arc All-in-One Power Systems 300, Руководство по эксплуатации и список запасных частей

Страница: 117 / 204

AIR IN ARC
®
300 SERIES ALL-IN-ONE POWER SYSTEM
®
SECTION 7: TROUBLESHOOTING
090010-OP_r0 PAGE - 99
7.1 GENERAL INFORMATION
The information contained in this section has been
compiled from years’ worth of information gathered
from the field. It contains symptoms and usual
causes for the most common types of problems that
may occur. All available data concerning the trouble
should be systematically analyzed before undertak-
ing any repairs or component replacement.
A visual inspection is worth performing for almost all
problems and may avoid unnecessary additional
damage to the machine. The procedures which can
be performed in the least amount of time and with the
least amount of removal or disassembly of parts,
should be performed first. Adherence to a routine
maintenance regimen will minimize the occurrence of
many common problems. Refer to
Section 6.3,
Maintenance Schedule Table for a typical mainte-
nance regimen program.
Although Vanair
®
strives to anticipate situations that
may occur during the operation life of the machine
package, the
Troubleshooting Guide may not cover
all possible situations. Be aware that additional trou-
bleshooting information may be found in other
sources such as the Engine Operator’s Manual.
Should the situation remain unresolved after
exhausting available sources, contact the Vanair Ser-
vice Department at:
Phone: 800-526-8817 (toll free)
Phone: 219-879-5100
Fax: 219-879-5335
NOTE
When contacting the Vanair Service
Department, please have machine serial
number on hand to quickly expedite
service. See Figure 7-1 for machine serial
plate location.
SECTION 7:
TROUBLESHOOTING
WARNING
DO NOT operate any of the Air N Arc 300
Series All-In-One Power System’s
functions if there is a known unsafe
condition. Disable the equipment by
disconnecting it from its power source.
Install a lock-out tag to identify the
equipment as inoperable to other
personnel to prevent accidental
application.
WARNING
Before starting, performing maintenance,
or replacing parts, relieve the entire
system pressure by opening the air tank
drain valve, which will vent all pressure
to the atmosphere.
Figure 7-1: Machine Serial Plate Location