Vanair Air N Arc All-in-One Power Systems 300, Руководство по эксплуатации и список запасных частей

Страница: 70 / 204

SECTION 5: OPERATION AIR N ARC
®
300 SERIES ALL-IN-ONE POWER SYSTEM
®
PAGE - 52 090010-OP_r0
The E indicates Electrode because some welding rods
are not electrodes. The 60 in 6010 indicates the tensile
strength in psi. 60,000 lbs.
The last 2 digits indicate position and polarity along with
what type flux. See
Table 5C .
5.5 OPERATING THE GENERATOR
For a detailed account concerning the Generator Mode
ON and OFF functions, consult
Appendix B , Section
B.5.1 an Section B.5.2 .
To operate the generator:
1. Start the engine.
NOTE
The Power System is designed to
support a multi-function project.
However, if the generator is operating at
a high percentage of its rated capacity,
and the welder and air compressor are
also being used, the resulting drop in
engine speed may produce a low voltage
condition that will damage the generator
and power tools being used.
TABLE 5C: WELDING ROD TYPE, POLARITY AND FLUX CODES
DIGIT TYPE OF COATING WELDING CURRENT
10 High cellulose sodium DC+
11 High cellulose potassium AC or DC+ or DC-
12 High titania sodium AC or DC-
13 High titania potassium AC or DC+
14 Iron powder titania AC or DC- or DC+
15 Low hydrogen sodium DC+
16 Low hydrogen potassium AC or DC+
27 Iron powder iron oxide AC or DC+ or DC-
18 Iron powder low hydrogen AC or DC+
20 High iron oxide AC or DC+ or DC-
22 High iron oxide AC or DC-
24 Iron powder titania AC or DC- or DC+
28 Low hydrogen potassium iron powder AC or DC+