MS-350 NP Operating Instructions Ver 4.02E
21
x x x
[ F ] 0 0 0 0 0
x
x
: H 1 4 0 T 0 . 0 C 1 0 0
x x x
[ F ] 0 0 0 0 0
x
x
: H 1 4 0 T 0 . 0 C 1 0 0
x x x
[ F ] 0 0 0 0 0
x
x
: H 1 4 0 T 0 . 0 C 1 0 0
MENU SELECT
PUSH UP/DOWN KEY
AUTO CYCLE TIME
PUSH ENTER KEY
AUTO CYCLE TIME
1.5s
x x x
[ F ] 0 0 0 0 0
x
x
: H 1 4 0 T 0 . 0 C 1 0 0
1
Press the key to place the cursor on the
last digit of C (cooling temperature) so that
it flashes.
2
Press the or key to input the desired
cooling temperature.
[Setting range : Between 100˚F and the
seal-heating temperature]
1
Press the MENU
key.
Press the key and select the menu
“AUTO CYCLE TIME”.
2
Press the ENTER
key to select the
menu.
3
Set the auto cycle interval time by
adjusting values with the arrows and
keys.
[Setting range : 0.1 ~ 5.0 sec.]
4
Press the ENTER
key to confirm the
setting.
5
Press the AUTO ON/OFF
key to
operate the machine in auto-cycle interval
mode. The auto-cycle mode lamp turns
ON. The machine operates with the set
interval time.
To deactivate the auto cycle interval mode,
press the AUTO ON/OFF
key again.
Set the cooling temperature
9-3 Auto-cycle and cycle interval time setting
The cursor flashes here
Attention
Be sure to allow sufficient
cooling for each seal cycle.
Attention
Setting is only for using the “AUTO
CYCLE INTERVAL” mode.