Value Hobby Sabre-44 3D Profile, Инструкция по эксплуатации

Страница: 8 / 19

www.valuehobby.com/sabre-44.html
8
Step4. Carefully use a hobby knife to trim the
covering 1.5mm (0.06in) from inside the lines, both
on the top and bottom. (Note: Don’t cut into the
wood)
Step5. Apply some epoxy to the exposed wood on
the top and bottom of the wing and fuselage.
Step6. Slide the wing into the position.
Double-check the alignment as described in step3.
Allow the epoxy to fully cure before proceeding.
Section 3: Aileron Installation
Required items:
Aileron (2)
Hinge (8)
Step1. Insert four pieces of hinges into the slot in
the aileron.