•
Adjust the seat forwards or backwards.
•
Pull the forward/backward adjustment lever upwards.
•
Move the seat forwards or backwards to the desired position.
•
Turn the longitudinal suspension on or off.
•
To turn on the longitudinal suspension, turn the lever to the rear position.
•
To turn off the longitudinal suspension, turn the lever clockwise 180° to
the front position.
•
Adjust the suspension according to the operator weight.
•
Pull the suspension adjustment lever until the compressor starts.
The compressor runs and the suspension adjusts automatically
according to the operator's weight.
If the operator is lighter than the previous operator, the compressor runs
momentarily, the excess pressure is released, and the seat lowers.
The suspension setting remains stored in the seat memory even if the
tractor is switched off.
The seat suspension travel is 100 mm (± 50 mm) regardless of the
starting height. The suspension area is limited to 100 mm for safety
reasons.
•
Adjust the height of the seat.
The seat has a stepless height adjustment range of 80 mm (±40 mm from the
seat middle position).
•
Lift the seat by pulling the height adjustment lever upwards until the
desired height is reached (the compressor runs continuously).
When the lever is released, the compressor stops and the seat stays at
that height. If you set the seat too high so that the room for upward
movement is less than 50 mm, the seat lowers automatically to the
highest permissible position.
•
Lower the seat by pressing the height adjustment lever downwards until
the desired height is reached.
If you set the seat too low so that the 50 mm downward suspension is not
possible, the seat automatically rises to the lowest limit the next time you
touch the lever.
If you sit very still on the seat during the adjustment, the seat may rise to
the previous height in the memory.
When the seat is locked at a new height, you hear a faint click.
•
Adjust the stiffness of the seat suspension.
•
When the lever is at the back position, the suspension is at its firmest.
•
When the lever is at the front position, the suspension is at its softest.
•
Fasten the seat belt to the anchor points on the seat.
•
Adjust the backrest inclination.
•
Pull the backrest inclination lever up.
•
Set the backrest to the desired position.
•
Adjust the armrest.
•
Remove the cover.
•
Change the armrest position in the mounting slot.
3. Operation
- 58 -
