46
Installation
1. Carefully unpack the kit, as the logs are fragile.
2. Install the steel platform around the burner as
indicated. The openings in the platform should be
underneath.
3. Place log 21 as shown with the pin in the hole, set
back about 1/4” from the burner.
4. Place log 22 from on top of log 21, across the burner
to the front platform.
Installed platform
21
22
21
Split Wood Kit 1505SWKV2
Material required
• Black steel platform (supplied with appliance)
• Split Wood Kit, which contains:
• 9 logs (numbered)
• 1 bag of gray/black embers
28
22
26
20
21
24
27
25
23
Installation
Fuel Beds
Note:
Use of this log set may increase the possibility of
soot formation when air shutters are set to the
minimum setting. Although LT1 units are fitted
with a minimum air shutter stopper intended to
prevent sooting with most log sets, it is possible
some sooting may occur when using this log set
and the air shutter is set to minimum position.
Evaluate the flame picture carefully after the unit
has warmed up for fifteen minutes, and avoid
setting the air shutter to minimum when there
is limited rise in the venting system or the flame
appears overly luminous and lazy with smoke
trailing off the flame tips.
Refer to page 56 for the location and function of
the air shutter adjustment lever.
