Valor 2200JN, Инструкция по установке и эксплуатации

Страница: 42 / 76

42
Fold fl at
standoff s
2200J
Installation
Install the Standoff s
The standoff s are supplied fl at. Bend them as shown
and fi x them to the top of the fi rebox.
Note: If installing with an all
steel framing, the top standoff s
are not necessary. Ensure that
the framing is self-supporting,
that is it NOT supported by the
engine.
Install 6-5/8” x 4” Vent Adapter (if required)
This unit is supplied with a 5” x 8” vent outlet which
can be fi eld-converted to a 4” x 6-5/8” vent outlet by
installing the vent adapter supplied with the appliance.
Install LDK HeatShift Duct Kit’s take-off
collars to appliance
See installation instructions packed with the LDK kits
for details.
Prepare Appliance for Wiring
For Decorative Lighting and optional 2200ULK—
Underbed Lighting Kit
(if used)
Wiring for the overhead lighting and RBWSK kit
is accessible from the rear panel of the appliance
and therefore it should be done BEFORE the
fi nal positioning of the fi replace in the framing.
The fi replace is equipped with a decorative lighting
located above the fi rebed inside the fi rebox. The
lighting is pre-wired at the factory and
must be
connected to the electrical system of the home
PRIOR to the fi nal positioning of the fi replace
into
the framing. The decorative lighting is operated by the
fi replace’s remote control handset.
Additionally, the 2200ULK—Underbed Lighting Kit
is off ered as an option (sold separately) to provide
decorative light under the fuel bed. This kit
is optional
and if used, the wiring is also accessible from
the rear of the appliance and therefore, it must
be installed BEFORE the fi nal positioning
of the
fi replace into the framing. It is operated by a dimmer
switch (not supplied) installed outside the fi replace.
Use the instructions provided with the kit for the
installation.
All electrical installations must be performed by
a qualifi ed electrician and must be electrically
wired and grounded
in accordance with local codes,
or, in the absence of local codes, with the National
Electrical Code, ANSI/NFPA 70 or the Canadian
Electrical Code, CSA C22.1 .
QUALIFIED
INSTALLER